Description
750 Millivolt Replacement Thermopile Generators have long been used in self-powered heaters and hot water equipment.
It has been proven in millions of appliances as the contractor's preferred thermopile and are found in many of today's self powered gas fireplaces.
Working Instructions:
1). Keep the thermopile heated in the 1/3 of the head location, Don't heat the back place to heater brass sleeve.
2). Because of High Resistance inside, The thermopile need around 1-2 minutes to be heated and increase to at least 750mV ( our reset voltage is around 800-900mV)
3) Do not take it off untill you heated it around 2 minutes
4) Do not bend the fireplace thermopile too hard on the crimped part and inside wires or it may cause short circuit and low voltage problem
5) If any problem, please contact us for customer service.
Features
- This thermocouple used for fireplace or water heater Internal resistance (25°C), resistance around 3,000 mΩ and 4,000 mΩ
- Normal working temperature 700-750°C. ( The thermopile should be heated around 2 minutes because inside high resistance, then the voltage will increase to above 750mV)
- Connecting type: spiral type and two-pole plug-in type ( The head should be heated in the 1/3 of the head location, Or the voltage may not increase to the reset opening valve voltage)
- Lengths: 24 inches (609mm)Universal Thermopile
- Do not bend the fireplace thermopile too hard on the crimped part and inside wires or it may cause short circuit and low voltage problem