Note: These solderless 4 pin connectors are only suitable for 10mm wide WATERPROOF RGB 5050 LED strip that has 4 copper contacts at the cutting line. Precautions: The 4 pins in the connectors should totally penetrate the 4 copper contacts on the WATERPROOF LED strip to ensure good electrical conductivity. So, when you cut your LED strip into 2 LED strips, you should cut very carefully along the cutting line, to make sure the area of the copper contacts on the 2 LED strips are the same (not a bigger area of copper contacts on one LED strip, and a smaller area on the other LED strip). If the area of the copper contacts on the LED strip is too small, then the 4 pins in the connectors can not totally penetrate the 4 copper contacts, and there will be poor electrical conductivity. As a result, you may get only 2 different colors or even no colors at all. Installation Instructions: 1.Carefully cut off the WATERPROOF RGB 5050 LED strip along the cutting line, so that the area of the 4 copper contacts on each LED strip is the same. 2.Remove the tape on the backside of the LED strip around the area of the 4 copper contacts, to expose the 4 copper contacts. 3.Make sure to match the + electrode on the connector to the + electrode on the LED strip. 4.Adjust the contact points between the 4 pins in the connector and the 4 copper contacts on the LED strip, to make sure the 4 pins in the connector can totally penetrate the 4 copper contacts on the LED strip. Then use your finger to press a little hard on the LED strip so that the 4 pins in the connector can go through the 4 copper contacts on the LED strip and then go into the LED strip a little. 5.Close the LED strip in the connector, make sure the 4 pins in the connectors totally penetrate the 4 copper contacts on the LED strip. Package includes: 10x 4-pin connectors for 10mm wide Waterproof RGB 5050 LED strip
- Waterproof-design Easy-Clasp Solderless Connectors, only work for 10mm wide WATERPROOF SMD 5050 RGB LED Strips.
- For example, it works for SUPERNIGHT, econoLED, eTopxizu,WenTop, LEDMO and Tingkam WATERPROOF RGB 5050 LED strips, etc.
- Easy to Use: No need to solder. Just clasp your prepared led strip section into the connector to get connected.
- Provide solderless, gapless and seamless connection for WATERPROOF SMD5050 RGB LED strips
- From TronicsPros: Package Comes with Unique Amazon Barcode "X0010A5W2B". 10pcs inside.