Description
(How to install and remove )
1. Clean the surface to attach and spray a little water to help increasing adhesion.
2. Pump the center button 7-8 times until the red line is not visible.
3. Tighten the knob clockwise.
4. Push card or spoon through the rubber plate and wall to remove it.
(Warm tips)
1. As you use it for a long time, a tiny refilled air in the suction cup may pop up the red line.
In this case, please press the center button again until the red line is not visible to pump air out again.
It is OK to repump when the button comes up without the red line.
2. Please clean up the suction cup with flowing water and make sure there are no other particles on the suction cup and wall when suction does not work well or reuse.
NO DRY NEEDED.
3. Please check the knob is locked; if not, tighten clockwise.
(Dimension)
Weight/EA = 3.7 ounces
Dimension = 4.8(L) X 2.8(W) X 3.0(H)
Holder top hole diameter = 24mm
Holder bottom hole diameter = 18mm
*This product does not work at the "DRYWALL."
Features
- SUPER HEAVY DUTY SUCTION - It uses water pump principle that air is absorbed by the pressure difference according to the up and down movement of the button and it attaches tightly on the wall. Since it has double pumps, as you press more times(typically until you don't see the red line), suction power is getting stronger
- ADJUSTABLE SWIVEL DESIGN - It could be adjusted and stopped at any angle, which is from the wall down to 45 degrees by tilting down
- CURVED SURFACE - It can be attached on the non porous curved surface that has radius more than 400 mm
- LONG LASTING UP TO 18 lb - It can hold up to MAX 18 lb load on the non-porous surface such as woods, tiles, glass, mirror, PVC board, Acrylic board, antique bricks metal, etc
- REINFORCING INDICATOR FOR LONG LASTING - When the red line appears on the button, just push the button several times to reinforce the suction power