Pouring Shield for KitchenAid 4.5 and 5 qt Mixers, Replace KN1PS Pouring Shield

Name: Bowl Pouring Shield Tilt Head Material: Plastic Color: Clear Attachments: mixer，Blender Type: Stand Model: KN1PS Please Note: This section doesn't fit kitchenaid professional 5 plus mixer Please check the model number before purchasing to make sure it is what you need. We provide clear pictures, measurements where possible. Please refer to Figure 2-3 for size details, Please allow 0.5-1 inch difference due to manual measurement.(1inch=2.54cm) Installation Pouring Shield: Turn the Speed Control to the OFF position and unplug the mixer from the outlet. Attach the bowl along with the flat beater, dough hook, or wire whip. Lower and lock the motor head. From the front of the mixer, slide the pouring shield over the bowl until the shield is centered. The bottom rim of the shield should fit within the bowl. Using the Pouring Shield : For the best results, rotate the shield so the motor head covers the "U" shaped gap in the shield. The pouring chute will be just to the right of the attachment hub as you face the mixer.Pour the ingredients into the bowl through the pouring chute. Removing Pouring Shield : Turn the Speed Control to the OFF position and unplug the mixer from the outlet. Slide the pouring shield off the bowl from the front of the mixer. To Clean Pouring Shield： Wash the Pouring Shield in warm, soapy water Or place it in the top rack of your dishwasher. Note: Do not scrape bowl while the mixer is running. Turn mixer off. Slide the Pouring Shield off the bowl, lift the mixer head, and scrape.