Description
Thermocouple is a replacement sensor for patio space heaters the head need to be heated always Operation Instructions 1). install the thermocouple on a pilot bracket or heater mounting plate fixed by clips 2). Keep the tip at around 5mm distance from the burner hole in right height. 3). Faston the thermocouple nut M8 on the valve end tightly (Check if your valve end thread if 8mm before you buy) 4). Connect two flat terminals well with the current tilt switch terminals. 5). Open gas and push your valve around 5-10s till the thermocouple head is heated enough. 6). Release your hand and it work properly If when you release hand, gas valve shut off again, Please check a. If your thermocouple is always be heated on flame b. If the thermocouple end is well connect with valve c. If the terminals connect tilt switch well.
Features
- Thermocoupler For Most Brand of Propane Patio Heaters But also need compare the head dimensions
- Two wire 30cm and 20cm, Total thermocouple length 350mm
- 4.8mm Flat terminal on end for dump switch
- Head need to Be fixed by clips or on install to Pilot bracket
- Thermocouple connect gas valve act as a flame failure safety device Thermocouple M8*1